RV Window Awning Lock Instructions

STEP 1: Open the window awning and secure it to the rig.

STEP 2:

Make sure the soft or loop side of a Grommet Strap is facing you. Borrowing an existing rail screw, secure the Grommet Straps 6” from each end of the awning rail.

STEP 3:

Leave the Grommet Strap hanging as you roll up the awning. Next, extend the Grommet Strap up and over the aluminum awning cover. This identifies the location where you will place the Hi-Temperature Hook material. Clean the aluminum awning cover with alcohol where the Hi-Temp Hook material will attach. It is important to clean this area to remove residual buildup of dirt and grime. Failure to adequately clean will result in failure of the Hook adhesive.

STEP 4:

Peel off the backing of the Hi-Temp Hook Sticky Back. Attach the Hook material at the appropriate places on the awning cover so the Grommet Straps can be secured to it when they are brought up and over the awning cover. Let the Hook set for 24 hours before attaching the Grommet Strap to it in order to allow the adhesive to set up properly.

STEP 5:

It is not necessary to take out your ladder. Standing on the ground, simply insert the hook end of your Awning Wand into the loop on the Grommet Strap and push the strap up and onto the Hook. Repeat at the other end. This will secure your awning and you are ready for travel. (See picture below) If you need a longer Awning Wand check out the two piece 54” Awning Wand available from Coil n’ Wrap. The loop on your strap is smaller than shown in the picture.

STEP 6:

To open the awning, use your Awning Wand to grasp the loop and pull down on the strap, releasing it from the Hook.

Another cool little product from the innovators at
www.coilnwrap.com 866-603-8388

$ 12.00

Return to Product Description Page

Order Product